Shift Lever

Shift Lever Replacement - On Vehicle
Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the steering column trim covers.
3. Disconnect electrical connector from traction control harness and feed harness out of column. Observe the harness routing and location to assist in reassembly.
4. Remove the shift lever retaining screw.
5. Pull the shift lever upward to remove it from the linear shift assembly.

Installation Procedure





1. Push the shift lever downward to engage it into the linear shift assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the shift lever retaining screw.
^ Tighten the shift lever retaining screw to 20 Nm (15 ft. lbs.).
3. Feed the traction control harness back through the column. Use care to route the harness as previously observed.
4. Install the steering column trim covers.
5. Enable the SIR system.