Console Replacement - Overhead

Console Replacement - Overhead

Removal Procedure





1. With a flat-bladed tool, gently pry open at the front of the roof console trim plate (1).
2. Remove the console trim plate.
3. Remove the fastener (2) at the center of the roof console.
4. Using your index finger, release the garage door opener wiring from the front retainer clip in order to remove the console from the roof.
5. Slide the roof console (3) rearward and downward from the locking tabs (4).




6. Disconnect the electrical connector for the garage door opener (2) and sunroof switch (1) (if equipped).
7. Remove the overhead console.



Installation Procedure





1. Connect the electrical connectors to the garage door opener and the sunroof switch (if equipped).
2. Install the overhead console (3) into the headliner opening.
3. Secure the garage door opener wire to the front retainer clip.
4. Make sure the locking tabs (4) are properly positioned.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the fastener (2).

Tighten the fastener to 1.5 N.m (13 lb in).

6. Install the roof console trim plate (1) to the roof console (3).
7. Gently push upward in order to lock the trim plate (1) to the roof console.