Fog Lamp Replacement - Front

REMOVAL PROCEDURE

CAUTION: Refer to Halogen Bulb Caution in Service Precautions.




1. Disconnect the fog lamp socket electrical connector (2).
2. Twist counterclockwise 45 degrees in order to remove the bulb (1) from the lamp housing.
3. Remove the fasteners retaining the bracket-to-lamp.
4. Remove the fog lamp bracket.
5. Remove the fog lamp housing from the retention clips.

INSTALLATION PROCEDURE




1. Install the fog lamp housing to the retention clips.
2. Install the fog lamp bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the bracket-to-lamp fasteners.

Tighten
Tighten the fasteners to 6 N.m (53 lb in).

4. Install the fog lamp bulb into the housing.
5. Twist clockwise 45 degrees the bulb (1) in order to secure.
6. Connect the fog lamp electrical connector (2).
7. Aim the fog lamps as needed. Refer to Fog Lamp Aiming Procedure.