Lock Housing - Assemble

Lock Housing Assembly - Assemble - Off Vehicle





1. Lubricate the switch actuator pivot pin (2) with synthetic grease. Install the switch actuator pivot pin (2).
2. Install the windshield wiper and washer switch assembly (1) into the lock housing cover and sleeve assembly.

Important: The bottom of the dimmer switch rod actuator (3) must rest on the bend of the dimmer switch rod.





3. Lubricate the dimmer switch rod actuator (3) with synthetic grease. Install the dimmer switch rod actuator (3) to the column housing cover end base plate (2).
4. Install the column housing cover end base plate (2) to the lock housing cover and sleeve assembly (1).
5. Install the lock housing cover and sleeve assembly (1) onto the steering column.
6. Align the dimmer switch rod to the dimmer switch rod actuator (3).

Notice: Refer to Fastener Notice in Service Precautions.





7. Install the 3 pan head 6-lobed socket tapping screws (1), (2), (3). Tighten the pan head 6-lobed socket tapping screws (1) starting at the 12 o'clock position.
Tighten the screws to 9 Nm (80 inch lbs.).





8. Mount the cruise control connector (3) onto the base plate (1).
9. Install the column housing cover end cap (2).
10. Install the steering column lock cylinder set.