Instrument Panel Compartment - Replacement
REMOVAL PROCEDURECAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Open the instrument panel storage compartment door.
3. Remove the fasteners (2, 7) that retain the instrument panel storage compartment assembly (8) to the instrument panel.
4. Remove the 2 fasteners from inside the instrument panel storage compartment.
5. Partially remove the instrument panel storage compartment assembly (8).
6. Disconnect the electrical connectors.
7. Remove the instrument panel storage compartment.
8. Remove the switches from the instrument panel storage compartment, if necessary. Refer to the following procedures:
^ IP Compartment Lamp Switch
^ Valet Switch Replacement.
^ Traction Control Switch Replacement in Antilock Brake System
INSTALLATION PROCEDURE
1. Install the switches to the instrument panel storage compartment, if necessary. Refer to the following procedures:
^ IP Compartment Lamp Switch
^ Valet Switch Replacement
^ Traction Control Switch Replacement in Antilock Brake System
2. Partially install the instrument panel storage compartment.
3. Connect the electrical connectors.
4. Install the instrument panel storage compartment assembly (8) to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the 4 fasteners (2, 7) in order to retain the instrument panel storage compartment to the instrument panel.
Tighten
Tighten the fasteners 2 N.m (18 lb in).
6. Install the 2 fasteners to the inside of the instrument panel storage compartment.
Tighten
Tighten the fasteners 2 N.m (18 lb in).
7. Close the instrument panel storage compartment door.
8. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.