Sun Visor: Service and Repair

Sunshade Replacement

Removal Procedure





1. Remove the fasteners from the outboard bezel.
2. Carefully pull down on the sunshade in order to expose the electrical connector.
3. Disconnect the electrical connector.
4. Remove the sunshade.



Installation Procedure





1. Install the fastener that retains the center receptacle (2). (if removed)
2. Connect the electrical connector (3).
3. Push the electrical connector and the wiring above the headliner.
4. Position the sunshade outer bezel in place.
5. Align the fastener holes.

Notice: Refer to Fastener Notice in Cautions and Notices.


Important: Do not pinch the wiring when you install the fasteners.


6. Install the fasteners (2) that attach the bezel.

Tighten the fasteners to 1.5 N.m (13 lb in).

7. Reposition the sunshade.