Compressor Mounting Bracket Replacement
TOOLS REQUIREDJ 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Remove the engine splash shield.
3. Disconnect the left engine oil cooler line at the oil filter adapter.
4. Remove the bolt that retains the compressor hose assembly (1) to the compressor.
5. Remove the A/C compressor mounting bracket retaining bolts.
6. Remove the A/C compressor bracket from the compressor.
7. Remove the A/C compressor mounting bracket.
INSTALLATION PROCEDURE
1. Install the A/C compressor mounting bracket.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the A/C compressor mounting bracket retaining bolts.
Tighten
Tighten the front bracket bolts to 50 N.m (38 lb ft).
3. Tighten the side bracket bolt.
Tighten
Tighten the bolt to 100 N.m (74 lb ft).
4. Install the compressor hose bolt (1).
Tighten
Tighten the bolt to 33 N.m (24 lb ft).
5. Connect the left engine oil cooler line at the oil filter adapter.
6. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
7. Leak test the fittings of the component using the J 39400-A.
8. Install the engine splash shield.