Heater Pipe Replacement - Inlet
TOOLS REQUIREDJ 38185 Hose Clamp Pliers
REMOVAL PROCEDURE
1. Drain the cooling system. Refer to Draining and Filling Cooling System.
2. Remove the vacuum control solenoid valve.
3. Disconnect the heater hoses from the heater inlet pipe (1) using the J 38185.
4. Remove the heater pipe clamp bolts (1).
5. Remove the heater pipe clamp bolt (4).
6. Disconnect the heater hose (3) from the heater inlet pipe.
7. Remove the heater hose.
INSTALLATION PROCEDURE
1. Install the heater pipe (1) into position.
2. Connect the heater hoses to the heater inlet pipe using the J 38185.
3. Install the bracket bolts (1).
4. Install the bracket and bolt (4).
5. Connect the heater hoses.
6. Install the vacuum control solenoid valve.
7. Fill the cooling system. Refer to Draining and Filling Cooling System in Cooling System. Service and Repair