A-Note

REMOVAL PROCEDURE




1. Remove the battery.

IMPORTANT: Note the position of the horn trumpet prior to removal in order to aid in the installation.

2. Remove the bolt securing the horn assembly to the vehicle.
3. Disconnect the electrical connector on the horn assembly.
4. Remove the horn assembly.
5. Remove the nut securing the horn (1) to the bracket.

INSTALLATION PROCEDURE




1. If wiring repairs are needed, refer to Splicing Copper Wire Using Splice Sleeves in Diagrams.
2. Install the new horn (1) to the original bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the supplied lock washer and nut.

Tighten
Tighten the supplied nut to the original bracket to 10 N.m (89 lb in).

4. Ensure the trumpet is in the same position as noted in the removal procedure.
5. Install the new 2 pin electrical connector to the new horn.
6. Ensure the locking tabs are secure.
7. Connect the electrical connector to the new 2 pin connector.
8. Locate the tab on the horn assembly bracket to the hole in the vehicle body.
9. Install the bolt in order to secure the horn assembly (1) to the vehicle.

Tighten
Tighten the bolt to 17 N.m (12 lb ft).

10. Install the battery.