Electronic Suspension Control Module Replacement
Electronic Suspension Control Module ReplacementRemoval Procedure
1. Remove the rear compartment trim panel.
2. Remove the rear seat cushion.
3. Remove the rear seat back.
4. Disconnect the electronic suspension control module connectors.
5. Remove the nuts from the electronics bay board.
6. Tilt the electronics bay board to access the electronic suspension control module.
7. Remove the electronic suspension control module from the electronics bay board.
Installation Procedure
1. Install the electronic suspension control module in the right electronics bay.
2. Install the electronics bay board.
Notice: Refer to fastener Notice in Service Precautions.
3. Install the nuts on the electronics bay board.
Tighten two screws to 9 Nm (80 inch lbs.).
4. Connect the electrical connectors to the electronic suspension control module.
5. Install the rear seat back.
6. Install the rear seat cushion.
7. Install the rear compartment trim panel.
8. Perform the electronic suspension control module calibration. Programming and Relearning
9. Inspect the Trim Height.