SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle

- Tools Required
- J41252 Steering Column Holding Fixture





1. If reusing the original inflatable restraint steering wheel module coil, refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift).

Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the orange tab from the new inflatable restraint steering wheel module coil until the installation is complete.

2. Feed the inflatable restraint steering wheel module coil connector through the steering column housing.
3. Align the inflatable restraint steering wheel module coil with the horn tower on the turn signal cancel cam assembly.
4. Install the wire protector into the support bracket.
5. Install the retaining ring.





6. Remove and discard the orange tab if using a new inflatable restraint steering wheel module coil.





7. Install the inflatable restraint steering wheel module coil connector (1) to the Fused jumper assembly connector (2).





8. Install the wire harness assembly into the wire harness strap (1).
9. Remove the steering column from J41352.