Ignition Lock Cylinder

Ignition Lock Cylinder Replacement - On Vehicle
Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the left closeout insulator panel.

Important: The multifunction turn signal and hazard switch does not have to be removed from the steering column when replacing the ignition lock cylinder. Let the multifunction turn signal switch hang free after the removal of the screws.

3. Remove the steering wheel.
4. Remove the inflatable restraint steering wheel module coil.
5. Remove the multifunction turn signal and hazard switch.
6. Put the key in the lock position.
7. Disconnect the steering column theft deterrent lock cylinder terminal connectors.
8. Connect a wire to the terminal connectors. This will make for easier installation.





9. Remove the warning buzzer switch (3).
10. Remove the ignition lock cylinder retaining screw (2).
11. Remove the retaining clip (4) from the steering column theft deterrent lock cylinder terminal connectors.
12. Remove the ignition lock cylinder (1).
13. Gently pull the terminal connectors through the steering column installation procedure.

Installation Procedure





1. Connect the pulled through wire to the terminal connectors from the ignition lock cylinder.
2. Gently pull the terminal connectors through the steering column.
3. Remove the wire from the terminal connectors.
4. Connect the steering column theft deterrent lock cylinder terminal connectors.





5. Install the ignition lock cylinder (1).

Notice: Refer to fastener Notice in Service Precautions.

6. Install the ignition lock cylinder retaining screw.
Tighten the ignition lock cylinder retaining screw to 25 Nm (22 inch lbs.).
7. Install the warning buzzer switch (3).
8. Install the retaining clip (4) to the steering column theft deterrent lock cylinder terminal wires and the lock housing cover.
9. Install the multifunction turn signal and hazard switch.
10. Install the left closeout/insulator panel.
11. Install the inflatable restraint steering wheel module coil.
12. Install the steering wheel.
13. Enable the SIR system.