Steering Wheel Control Switch

Steering Wheel Control Switch Assembly Replacement
Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system.
2. Remove the inflatable restraint steering wheel module.
3. Remove the steering wheel control switch pack retaining screws.
4. Note the routing of the electrical harness.
5. Remove the electrical harness from the harness clips.
6. Disconnect the electrical connector.





7. Remove the steering wheel control switch pack (1).

Installation Procedure





1. Install the steering wheel control switch pack (1) to the steering wheel.

Notice: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.

2. Reposition and secure the electrical harness to the harness clips as noted in the removal procedure.
3. Connect the electrical connector.

Notice: Refer to fastener Notice in Service Precautions.

4. Install the steering wheel control switch pack retaining screws.
Tighten the steering wheel control switch pack retaining screws to 1.8 Nm (16 inch lbs.).
5. Install the inflatable restraint steering wheel module.
6. Enable the SIR system.