Tie Rod End Replacement - Outer

Tie Rod End Replacement - Outer

- Tools Required
- J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.





2. Remove the tire and wheel.
3. Loosen the jam nut (2) on the inner tie rod assembly (1).





4. Remove the lock nut (3) from the outer tie rod end (1).





5. Install J 24319-B to the steering knuckle.
6. Using J 24319-B separate the outer tie rod from the steering knuckle.





7. Remove the outer tie rod (3) from the inner tie rod (1).

Installation Procedure





1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).





2. Connect the outer tie rod (2) to the steering knuckle (1).

Notice: Refer to fastener Notice in Service Precautions.





3. Install the outer tie rod (1) retaining nut (3).
Tighten the outer tie rod retaining nut to 75 Nm (55 ft. lbs.).

Important: Be sure the rack and pinion boot is not twisted or puckered during toe adjustment.

4. Install the tire and wheel.
5. Lower vehicle.
6. Adjust the toe alignment.