Shifter A/T: Service and Repair

Shift Control Replacement

Removal Procedure





1. Remove the console trim plate.
2. Unsnap the shift cable terminal from the shifter pin.
3. Disconnect the automatic transmission shift lock actuator solenoid wire harness connector.





4. Remove the shifter fasteners.
5. Remove the shifter assembly.

Installation Procedure





1. Position the shifter assembly into the console

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the shifter fasteners.
^ Tighten the shifter fasteners to 9 Nm (79 inch lbs.).





3. Insert the shift cable onto the shifter control.
4. Connect the automatic transmission shift lock solenoid wire harness connector.
5. Install the console trim plate.