Closeout/Insulator Panel Replacement - Left (LHD)

Closeout/Insulator Panel Replacement - Left (LHD)

Removal Procedure





1. Remove the fasteners (1) at the rear edge of the insulators in order to disengage the fasteners from the lower IP.
2. Push in on the snap tab retainers in order to release the insulator.




3. Disconnect the electrical connectors (1, 3) as necessary.




4. Slide the insulator panel (2) rearward toward the vehicle in order to clear the emergency brake bracket (1).



Installation Procedure





1. Slide the insulator (2) over the top of the emergency brake bracket (1).




2. Reconnect the electrical connectors (1,3).




3. Set the forward edge of the insulator onto the shelf of the carpeting at the front of the vehicle.
4. Align the insulator with the floor duct at the HVAC module.
5. Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.

Notice: Refer to Fastener Notice.

6. Install the insulator fasteners (1) into lower IP.

Tighten the fasteners to 2 N.m (18 lb in).