Dome Lamp: Service and Repair

REMOVAL PROCEDURE




1. Remove the overhead console.




2. Remove the three screws from the lamp retainer.

IMPORTANT: Care should be taken when rotating the lamp retainer not to snag or rip the flat wire harness.

3. Rotate the lamp retainer from right to left.
4. Replace the inoperative bulb.

INSTALLATION PROCEDURE

IMPORTANT: Care should be taken when rotating the lamp retainer not to snag or rip the flat wire harness.




1. Rotate the lamp retainer back into place.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the three fasteners fully driven, seated, but not stripped.
3. Install the overhead console.