Electronic Suspension Control Module Replacement (F55)

Electronic Suspension Control Module Replacement (F55)

Removal Procedure
1. Remove the rear storage compartment trim.





2. Remove the bay board fasteners (2).
3. Pull the bay board t1) away from the body and place the bay board (1) module side up in the rear compartment.





4. Remove the ESC module by depressing the locking tab (1), in order to release the ESC module (2) from the bay board.
5. Disconnect the harness connectors from the ESC module.

Installation Procedure





1. Connect the harness connectors to the ESC module (2).
2. Insert the ESC module (2) into the bay board tabs (3) and locking tab (1).





3. Install the bay board (1) to the vehicle body.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the bay board retaining nuts (2).
Tighten the nuts (2) to 9 Nm (80 inch lbs.).
5. Install the rear storage compartment trim.
6. Program the ESC module.
7. Use a scan tool in order to perform the Bump Stop Trim Set procedure.