Dash Integration Module Replacement (RHD)

REMOVAL PROCEDURE

IMPORTANT: Before replacement of the DIM module (1), record the personalization settings in order to transfer the settings after the DIM module (1) has been replaced.




1. Remove the left sound insulator.
2. Disconnect the DIM electrical connectors (2).




3. Depress inward on the locking tab (2).
4. With the locking tab (2) depressed, slide the DIM (1) downward.
5. Remove the module (1) from the bracket.

INSTALLATION PROCEDURE




1. Install the module to the bracket.
2. Slide the DIM upward until it is fully engaged.




3. Connect the DIM electrical connectors (2).
4. Install the left sound insulator.
5. Reprogram the Dash Integration Module. Refer to Body Control Module (BCM) Programming/RPO Configuration (DIM) or Body Control Module (BCM) Programming/RPO Configuration (IPM). Programming and Relearning