Head Restraint Motor Replacement - Front Seat
REMOVAL PROCEDURECAUTION: Refer to SIR Handling Caution in Service Precautions.
1. Remove the seat assembly.
2. Remove the head restraint.
3. Remove the seatback trim cover (7).
4. Remove the seat back cover and pad.
5. Remove the seat back frame.
6. Remove the block (2) from the lower seat frame (1).
7. Using a flat-bladed tool, disengage the retainer lock from the head restraint/power actuator assembly.
IMPORTANT: Ensure the electrical connector does not catch on the inner seat back frame upon the head restraint/power actuator assembly removal.
8. Firmly hold the seat back frame (1) pull outward the power actuator assembly (2).
9. Remove the power actuator assembly from the seat back frame.
INSTALLATION PROCEDURE
1. Feed the wire harness down through the seatback frame.
2. Install the head restraint/ power actuator assembly (2).
3. Carefully apply pressure to the head restraint I power actuator assembly in order to secure the retainer locks (3) to the seat back frame (1).
IMPORTANT: Ensure the holes are aligned for the block (2) in the seat back frame (1).
4. Install the seat back frame retaining block.
5. Ensure the electrical harness is not pinched and moves freely within the block.
6. Install the seat back frame.
7. Install the seat back cover and pad.
8. Install the seatback trim cover.
9. Install the head restraint.
10. Install the seal assembly.