Ignition Coil(S) Replacement - Bank 2

REMOVAL PROCEDURE

Locations View:

1. Remove the fuel injector sight shield.
2. Disconnect the ignition control module (ICM) electrical connector.
3. Remove the upper filler panel.




4. Using the removal sequence, remove the ignition cassette retaining bolts.
5. Carefully, remove the ignition cassette.

INSTALLATION PROCEDURE

IMPORTANT: Be sure the ignition cassette grounding spring and insulator are in place when installing the ignition cassette.

Locations View:

1. Connect the spark plug boots to the spark plugs. Carefully, install the ignition cassette.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the ignition cassette retaining bolts.

Tighten
Using the installation torque sequence, tighten the ignition cassette retaining bolts to 9 N.m (80 lb in).

3. Reconnect the ignition cassette electrical connector.
4. Install the upper filler panel.
5. Install the fuel injector sight shield.