Telescope Actuator Switch
Telescope Actuator Switch Replacement - On VehicleRemoval Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the steering column.
3. Remove the lower steering column trim cover retaining screws (2).
4. Remove the lower steering column trim cover (1) from the steering column closeout shroud.
5. Remove the wiring harness tie straps (2) from the steering column wiring harness.
6. Disconnect the tilt and telescope module electrical connectors (2).
7. Open the lower wiring harness shield (1) and remove the steering column wiring harness.
Note the direction the steering column wiring harness is routed in the lower steering column wiring harness shield for reinstallation.
8. Remove the tilt and telescope switch (2) from the lower steering column trim cover (1).
Installation Procedure
1. Install the tilt and telescope switch (2) to the loner steering column trim cover (1).
2. Install the steering column wiring harness (2) to the lower wiring harness shield (1).
3. Connect the tilt and telescope module electrical connectors (2).
4. Install the wiring harness tie straps (2) to the steering column wiring harness.
5. Install the lower steering column trim cover (13 to the steering column closeout shroud and upper steering column trim cover.
Ensure that the tabs (2) on the lower steering column trim cover engage with the tabs on the upper steering column trim cover then snap them together.
6. Install the lower steering column trim cover (2) retaining screws.
Tighten the lower steering column trim cover retaining screws to 3.5 Nm (31 inch lbs.).
7. Install the steering column.
8. Enable the SIR system.