Lock Cylinder Replacement - Door (with UA2)

Lock Cylinder Replacement - Door (with UA2)

Removal Procedure





1. Place the window in the full up position.
2. Remove the door trim panel. Refer toTrim Panel Replacement - Side Front Door (Service and Repair) .
3. Pull the rear of the water deflector far enough away from the door in order to access the outside door handle. Refer toWater Deflector Replacement - Front Door Service and Repair
4. Remove the outside door handle. Refer toDoor Handle Replacement - Front Outside (Service and Repair) .
5. Remove the E-clip (2) on the lock cylinder.
6. Remove the lock rod and arm.
7. Remove the roll pins (1).

1. Insert a suitable prying tool between the reinforcement (3) and the roll pin (1).
2. Pry the roll pin downward far enough to grasp the opposite end with pliers.
3. Remove the roll pin with the pliers.
4. Remove the remaining roll pin with a drift punch.

8. Remove the lock cylinder from the backside of the door handle.



Installation Procedure





1. If a new lock cylinder is to be installed, refer toKey and Lock Cylinder Coding in General Information, for the proper coding procedure.
2. Insert the lock cylinder into the cavity in the door handle.




3. Install the roll pins (1).
4. Secure the lock cylinder arm and rod to the lock cylinder with the E-clip (2).
5. Install the outside door handle. Refer toDoor Handle Replacement - Front Outside (Service and Repair) .
6. Install the water deflector. Refer toWater Deflector Replacement - Front Door Service and Repair
7. Install the door trim panel. Refer toTrim Panel Replacement - Side Front Door (Service and Repair) .