Ignition Lock Cylinder Case
Ignition Lock Cylinder Case ReplacementRemoval Procedure
Caution: Refer to SIR Caution In Service Precautions.
1. Disable to inflatable restraint steering wheel module.
2. Remove the turn signal cancel cam and upper bearing.
3. Remove the theft deterrent control module.
4. Remove the ignition lock cylinder.
5. Remove the ignition switch assembly.
6. Remove 3 pan head tapping screws (2) from the ignition lock cylinder case assembly (1).
Remove the ignition lock cylinder case from the steering column.
Installation Procedure
1. Align the ignition lock cylinder case assembly (1) with the steering column tilt head assembly.
Notice: Refer to Fastener Notice in Service Precaution.
2. Secure the ignition lock cylinder case assembly (1) to the steering column using 3 pan head tapping screws (2).
^ Tighten the screws to 7 Nm (62 inch lbs.).
3. Install the ignition switch assembly.
4. Install the ignition lock cylinder.
5. Install the theft deterrent control module.
6. Install the turn signal cancel cam and upper bearing.
7. Enable the inflatable restraint steering wheel module.