Ignition Switch

Ignition Switch Replacement

^ Tools Required
- J 42759 Ignition Switch Connector Release Tool

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the inflatable restraint steering wheel module. Service and Repair
2. Remove the theft deterrent control module.





3. Rotate the key alarm connector (1) 90 degrees.
4. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).
5. Disconnect the connector from the ignition switch assembly.
6. Remove the wires encased in the ignition switch clip (located on the side of the ignition switch).





7. Remove the ignition switch assembly (2) using J 42759.

Installation Procedure





1. Insert J42759 into the ignition lock cylinder case assembly (1) and slide the ignition switch assembly (2) in.
2. Connect the connector to the ignition switch assembly (2).

Caution: Refer to SIR Inflator Module Coil Caution in Service Precaution.





3. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
4. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
5. Install the wires back into the ignition switch clip.
6. Install the theft deterrent control module.
7. Enable the inflatable restraint steering wheel module.