Upper Control Arm Replacement
The content of this article reflects the changes identified in TSB- 05-03-08-020 Dated: December 12, 2005Upper Control Arm Replacement
^ Tools Required
- J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the shock absorber.
4. Remove the brake rotor.
5. Remove the upper control arm mounting nuts and bolts.
6. Remove the upper ball joint mounting nut.
7. Using J 43631 disconnect the upper ball joint from the knuckle.
8. Remove the upper control arm from the vehicle.
Installation Procedure
1. Install the upper control arm to the vehicle.
2. Connect the upper ball joint to the knuckle.
Notice: Refer to Fastener Notice in Service Precaution.
3. Install the upper ball joint to the knuckle retaining nut.
^ Tighten the nut to 20 Nm (15 ft. lbs.) plus and additional 180 degree turn.
4. Install the upper control arm to the frame mounting bolts.
^ Tighten the bolts to 175 Nm (129 ft. lbs.).
5. Install the brake rotor.
6. Install the shock absorber.
7. Install the tire and wheel.
8. Lower the vehicle.