48. Torque Converter Seal Installation
Torque Converter Seal InstallationTools Required
^ J8092 Universal Driver Handle
^ J44766 Seal Installer
1. Assemble J8092 onto J44766.
Notice: Install the seal onto the installation tool before installing into the case to prevent damage to the seal.
2. Install the seal (229) onto J44766.
Important: Align the torque converter seal with the bolt holes.
3. Install the NEW seal (229) into the housing (3).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the NEW seal bolts (228).
Tighten the seal bolts to 3.6 Nm (31.86 inch lbs.).
5. Install the NEW input shaft seal (430).