Shift Control Linkage Replacement
Shift Control Linkage ReplacementRemoval Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the nut from the shift control linkage rod.
3. Disconnect the shift control linkage rod from the shift control assembly.
4. Remove the manual shift shaft nut.
5. Remove the shift control linkage from the vehicle.
Installation Procedure
1. Install the shift control linkage to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the manual shift shaft nut.
Tighten the manual shift shaft nut to 15 Nm (11 ft. lbs.).
3. Connect the shift control linkage rod to the shift control assembly.
4. Install the nut to the shift control linkage rod.
5. Adjust the shift control linkage.
6. Lower the vehicle.