Wiper Arm Replacement (RHD)

WIPER ARM REPLACEMENT (RHD)

TOOLS REQUIRED
J 39822 Wiper Arm Puller

REMOVAL PROCEDURE




1. Set the wipers in the Park position.
2. Open the hood assembly.
3. The driver side wiper (4) aligns with an orange line at the tip of the wiper blade located at the center lower windshield.
4. The passenger side wiper (1) aligns with an orange dot at the inner tip of the wiper blade located on the center lower side of the windshield.
5. Remove the covers (2,5) from the wiper arm nuts (3,6).
6. Hold the wiper arm into position and remove the nut (3,6).




7. Remove the upper hood assist rods from the assist rod ball studs (1) if removing the driver side wiper arm.

NOTE: Apply pressure only at the end of the hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

8. Tilt the hood rearward to the air inlet grille panel.
9. Support the hood assembly.
10. Remove the wiper arm from the wiper arm drive spindle.

IMPORTANT: Use the J 39822 in order to remove the wiper arm if the wiper arm fails to loosen from the wiper arm drive spindle.

11. Clean the drive spindle knurls with a fine wire brush.
12. Remove the wiper blade from the wiper arm.

INSTALLATION PROCEDURE




1. Install the wiper blade onto the wiper arm.
2. Position the passenger side wiper arm so the wiper blade tip (1) aligns with the orange dot on the lower outer edge of the windshield.
3. Position the driver side wiper arm so that the wiper blade tip (4) aligns with the orange line on the lower center of the windshield.
4. Install the wiper arm onto the drive shaft.
5. Install the nut (3,6) on the wiper arm.


NOTE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: Hold the wiper arm into position while tightening the nut.

Tighten
Tighten the nut to 35 N.m (26 lb ft).





6. Connect the hood assist rods to the assist rod ball studs (1) on the hood assembly.
7. Install the wiper nut covers.
8. Close the hood.




9. Operate the wipers and wash pattern (2) in order to verify the proper operation.
10. Verify the driver side wiper does not exceed the drivers side wipe area (3).