Assist Rod Replacement - Hood

Assist Rod Replacement - Hood

Removal Procedure


Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1. Open and support the hood.




2. Release the clip retaining the hood assist rod (4) to the lower assist rod ball stud (3).

Notice: Apply pressure only at the end of the hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

3. Release the clip retaining the hood assist rod (4) to the upper assist rod ball stud (1).
4. Remove the hood assist rod (4) from the vehicle.



Installation Procedure





1. Press the hood assist rod (4) onto the upper hood assist rod ball stud (1).
2. Press the hood assist rod (4) onto the lower hood assist rod ball stud (3).
3. Ensure that both clips are fully seated on the hood assist rod (4).
4. Close the hood.