Turn Signal Cancel Cam & Steering Shaft Upper Bearing Spring
Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring ReplacementTools Required
^ J23653-SIR Steering Column Lock Plate
Removal Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the inflatable restraint steering wheel module coil.
3. Using J23653-SIR remove the bearing retainer.
4. Remove the shaft lock shield assembly (1).
5. Remove the turn signal cancel cam assembly (1, 2).
6. Remove the upper bearing spring (3).
Installation Procedure
1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install the bearing retainer.
5. Using J23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer into place.
7. Remove J23653-SIR from the steering shaft.
8. Install the inflatable restraint steering wheel module coil.
9. Enable the SIR system.