Dash Integration Module Replacement
DASH INTEGRATION MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the right sound insulator.
IMPORTANT: Before replacement of the DIM module (1), record the personalization settings in order to transfer the settings after the DIM module (1) has been replaced. Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM)Body Control Module (BCM) Programming/RPO Configuration (DIM).
2. Disconnect the DIM module electrical connectors (2).
3. Depress inward on the locking tab (2).
4. With the locking tab (2) depressed, slide the DIM module (2) downward.
5. Remove the DIM module (1) from the bracket.
INSTALLATION PROCEDURE
1. Install the DIM module to the bracket.
2. Slide the DIM module upward until the DIM module and the locking tab are fully engaged.
3. Connect the DIM module electrical connectors (2).
4. Install the right sound insulator.
5. Reprogram the DIM module (1). Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM)Body Control Module (BCM) Programming/RPO Configuration (DIM). Programming and Relearning