Mirror Replacement - Power Mirror

Mirror Replacement - Power

Removal Procedure

1. Remove the door trim panel to gain access to the power mirror wire harness connector. Refer to Trim Panel Replacement - Side Rear Door. Service and Repair
2. Remove the garnish molding. Refer to Garnish Molding Replacement - Front Door Frame (Garnish Molding Replacement - Front Door Frame) .




3. Disconnect the power mirror wire harness electrical connector (5) from the door module.
4. Disconnect the wire harness from the retainer clip (4).
5. Remove the mirror fasteners (3).
6. Remove the mirror (1) from the door.
7. Unseat the grommet (2).
8. Pull the wiring harness through the hole in the mirror patch.



Installation Procedure





1. Route the mirror wiring harness through the hole in the mirror patch.
2. Seat the grommet (2).
3. Install the mirror (1) into the door frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the mirror fasteners (3).

Tighten the mirror fasteners, in this order: forward, top, rear, to 9 N.m (80 lb in).

5. Install the mirror wire harness into the retainer clip (4).
6. Connect the power mirror electrical connector (5) to the door module.
7. Install the garnish molding. Refer to Garnish Molding Replacement - Front Door Frame (Garnish Molding Replacement - Front Door Frame) .
8. Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door. Service and Repair