Sunroof Control Module Replacement
SUNROOF CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
1. Disable the SIR system.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Remove the passenger side rear assist handle.
3. Remove the rear seat cushion.
4. Remove the rear seat back.
5. Remove the rear passenger seat belt retractor (4).
6. Remove the passenger side rear sail panel.
7. Carefully pull the upper center trim panel inward in order to allow clearance for the headliner.
IMPORTANT: Release the passenger side center pillar trim garnish molding upper retainer.
8. Carefully pull the passenger side of the headliner downward in order to release the center and rearward headliner roof magnets.
9. Reach inward between the headliner and roof panel in order to release the sunroof control module clip (3) securing the control module (1) to the sunroof module assembly (2).
10. With the clip (3) depressed, slide the control module toward the sunroof motor/actuator.
11. Disconnect the electrical connectors.
12. Remove the sunroof control module from the vehicle.
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the sunroof control module.
2. Install the sunroof control module tabs (2) into the slots (3) located on the sunroof module assembly.
3. Slide the sunroof control module (1) away from the sunroof motor/actuator until the sunroof control module is fully engaged to the sunroof module assembly.
4. Reposition the headliner to the center and rearward roof magnets.
IMPORTANT: Test the proper operation of the sunroof functions before installing the interior trim components.
5. Install the passenger side sail panel.
6. Install the passenger side rear seat belt retractor (4).
7. Install the rear seat back.
8. Install the rear seat cushion.
9. Align the upper center trim panel retainer, push inward in order to secure.
10. Reposition the passenger rear door opening weatherstrip seal.
11. Install the passenger side rear assist handle.
12. Enable the SIR system.
13. Close the passenger rear door.