Blower Motor Replacement
BLOWER MOTOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the right side sound insulator.
2. Remove the I/P compartment.
3. Remove the dash integration module from the bracket.
4. Remove the two rear dash integration module bracket fasteners.
5. Reposition the dash integration module bracket in order to remove the blower motor.
6. Disconnect the electrical connector (1) from the blower motor.
7. Disconnect the blower motor ventilation tube (2) from the module.
8. Remove the blower motor retaining fasteners (1).
9. Remove the blower motor from the vehicle.
INSTALLATION PROCEDURE
1. Install the blower motor into the blower motor housing.
2. Ensure that the blower motor gasket is properly aligned.
3. Install the blower motor retaining screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
4. Connect the electrical connector (1) to the blower motor.
5. Connect the blower motor ventilation tube (2) to the module.
6. Reposition the dash integration module bracket to its original position.
7. Install the 2 rear dash integration module bracket fasteners.
8. Install the dash integration module.
9. Install the I/P compartment.
10. Install the right side sound insulator.