Closeout/Insulator Panel Replacement - Right

Closeout/Insulator Panel Replacement - Right

Removal Procedure





1. Remove the fasteners (1) from the rear edge of the insulator panel.
2. Pull the closeout / insulator panel down in order to disengage the push pin type fasteners from the lower instrument panel.
3. Slide the closeout / insulator panel toward the rear of the vehicle.
4. Remove the closeout / insulator panel from the vehicle.



Installation Procedure

1. Place the forward edge of the closeout / insulator panel on the shelf above the carpeting at the front of the vehicle.




2. Align the insulator with the fastener holes on the insulator panel.
3. Install the push pin type retainers in order to hold the insulator panel in position.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the threaded fasteners (1).

Tighten the fasteners (1) to 2 N.m (18 lb in).