Electrical - Intermittent No Start/No Electrical Power

Bulletin No.: 03-06-03-009

Date: October 21, 2003

TECHNICAL

Subject:

Intermittent No Electrical Power, No Crank/Start (Align Engine Wiring Junction Block (Underhood Bussed Electrical Center (UBEC)) Connectors)

Models:
2003 DeVille

Condition

Some customers may comment on an intermittent no electrical power condition that leads to a no crank/start when the ignition is turned to START.

Cause

This condition may be due to the engine wiring junction block (Underhood Bussed Electrical Center (UBEC)) connectors not being fully seated to the engine wiring junction block causing a poor connection.

Correction

Ensure the three wiring harness connectors are properly installed to the engine wiring junction block/UBEC.

Repair Procedure

1. Disconnect the negative battery cable from the battery.





2. Remove the engine wiring junction (fuse) block/UBEC cover.

3. Remove the positive battery cable fastener and cable from the junction fuse block.

4. Loosen the 3 fasteners that retain the junction fuse block to the junction fuse block wiring harness connectors.

5. Release the 4 locking tabs that retain the junction fuse block to the base assembly.

6. Separate the junction fuse block from the wiring harness connectors.

7. Carefully align the junction fuse block to the wiring harness connectors.

Important:
Ensure the connectors are fully seated.

8. Connect the junction fuse block to the wiring harness connectors.

9. Engage the 4 locking tabs that retain the junction fuse block to the base assembly.

Tighten

Tighten the 3 fasteners that secure the junction fuse block to the wire harness connectors to 7 N.m (62 lb in).

10. Install the positive battery cable and fastener to the junction fuse block.

Tighten

Tighten the fastener to 15 N.m (11 lb ft).

11. Install the engine wiring junction (fuse) block/UBEC cover.

12. Connect the negative battery cable to the battery.

13. Verify that the condition has been corrected.

Warranty Information





For vehicles repaired under warranty, use the table.





Disclaimer