Crankshaft, Engine

Lower Crankcase	Bearing Bolt	M10 x 1.5 First Pass - In Sequence	15 ft. lbs.
		M10 x 1.5 Final Pass - In Sequence	+65°
	Perimeter Bolt	M8 x 1.25 - In Sequence	22 ft. lbs.
Crankshaft	Journals Crankshaft, Main, Diameter		2.5335-2.5341 in
	Runout #1 #5		0.0009 in
	Runout #2, #3, #4		0.0010 in
	Round		0.0002 in
	Taper		0.0002 in
	Width, #1, #2, #4, #5		0.9661-0.9709 in
	Thrust #3 Wall Width		0.9902-0.9941 in
	Runout		0.0016 in
	Square		0.0004 in
	Crankpin, Connecting Rod, Diameter		2.1239-2-1245 in
	Round		0.0002 in
	Taper		0.0002 in
	Width		1.7260-1.7307 in
	End Play Production		0.0020-0.0197 in
	Service - Maximum		0 0197 in
	Flange, Engine Flywheel Face Runout		0.0010 in
	Rear Seal Diameter		3.7748-3.7787 in
	Runout		0.0010 in
	Nose Diameter,0.0-21.0 mm (0.000-0.827 inch), From Front Face		1.3583-1.3681 in
	Runout		0.0039 in
	21.0-53.00mm (0.827-2.087 in.), From front Face		1.3737-1.3745 in.
	Runout		0.0012 in
	53.00 mm (2.087 in), From Front Face, to Rolled Fillet		1.3169-1.3209 in.
	Runout		0.0039 in.
	89.94-110.54 mm (3.541-4.352 in), From Front Face		1.7697-1.7717 in.
	Runout		0.0010 in.