Ignition Lock Cylinder Case

Ignition Lock Cylinder Case Replacement

Tools Required
^ J41396 Park Lock Cable Pliers

Removal Procedure

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
^ Air bag deployment
^ Personal injury
^ Unnecessary SIR system repairs

^ In order to avoid the above conditions, observe the following guidelines:
^ Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
^ If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system.

1. Disable the SIR system. Service and Repair
2. Remove the ignition lock cylinder.
3. Remove the ignition switch.
4. Remove the turn signal cancel cam and steering shaft upper bearing spring.
5. Remove the turn signal and multifunction switch assembly only.





6. Slide the ignition lock cylinder case bracket off of the steering column shaft assembly.





7. Remove the park lock cable assembly (1) from the ignition lock cylinder case in the following way:
7.1. Place the steering column-lock cylinder set into the OFF position.
7.2. Place the-shift lever clevis into the PARK position.
7.3. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
7.4. Disconnect the park lock cable assembly (1) from the ignition lock cylinder case.





8. Remove the 3 TORX screws (2) from the ignition lock cylinder case (1).
9. Remove the ignition lock cylinder case (2) from the steering column tilt head assembly.

Installation Procedure





1. Align the ignition lock cylinder case (2) with the steering column tilt head assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 3 TORX screws (2) into the ignition lock cylinder case (1).
Tighten the 3 TORX screws to 7 Nm (62 inch lbs.).





3. Place steering column lock cylinder set into the OFF position.
4. Place the shift lever clevis into the PARK position.
5. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
6. Adjust the park lock cable assembly.
6.1. Use the gear shift lever to put the column in the PARK position.
6.2. Put the ignition switch in the OFF-LOCK position. Remove the key.





6.3. Unlock the adjuster ring on the park lock cable assembly with J41396.
6.4. Pull on the cable until the park lock latch contacts the gear shift lever. Release the cable.
6.5. Lock the adjuster ring securely in place on the park lock cable assembly with J41396.
7. Inspect the park lock cable assembly.
7.1. Using the ignition lock cylinder, put the lock cylinder in the OFF-LOCK position. The gear shift lever should not be able to shift out of the PARK position.
7.2. Turn the key to the run position and put the gear shift lever in the NEUTRAL position.
7.3. With the gear shift lever in the NEUTRAL position the lock cylinder should not be able to go into the OFF-LOCK position.
7.4. Put the gear shift lever in the PARK position.
7.5. Remove the ignition lock cylinder.

Important: Press the ignition lock cylinder case bracket firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly to align.





8. Slide the ignition lock cylinder case bracket on the steering column shaft assembly.
9. Install the turn signal and multifunction switch assembly only.
10. Install the turn signal cancel cam and steering shaft upper bearing spring.
11. Install the ignition switch only.
12. Install the ignition lock cylinder.
13. Enable the SIR system.