Shift Lever

Shift Lever Replacement

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system.
2. Remove the steering column trim covers.





3. Disconnect the electrical connector from the traction control harness and feed the harness out of the column. Observe the harness routing and location to assist in reassembly.
4. Remove the shift lever retaining screw.
5. Pull the shift lever upward to remove the lever from the linear shift assembly.

Installation Procedure





1. Push the shift lever downward to engage the lever into the linear shift assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the shift lever retaining screw.
Tighten the screw to 20 Nm (15 ft. lbs.).
3. Feed the traction control harness back through the column. Route the harness carefully as previously observed.
4. Install the steering column trim covers.
5. Enable the SIR system.