Rear Position Sensor Replacement-Electronic Suspension

Rear Position Sensor Replacement - Electronic Suspension

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.
3. Disconnect the height sensor connector.
4. Disconnect the sensor link from the ball stud.
5. Loosen the sensor mounting nut.
6. Disengage the anti-rotation tab and slide the sensor downward.
7. Remove the sensor from the vehicle.

Installation Procedure





1. Insert head of the sensor mounting stud into the key hole.
2. Slide the sensor upward until the anti-rotation tab engages in the lower hole.

Notice: Refer to Fastener Notice in Service Precautions.

3. Tighten the sensor mounting nut.
^ Tighten the nut to 9 Nm (80 inch lbs.).
4. Connect the sensor link on the ball stud.
5. Connect the height sensor connector.
6. Install the wheel on the vehicle.
7. Lower the vehicle. Refer to Vehicle Lifting.