Backup Lamp: Service and Repair
BACKUP LAMP REPLACEMENTREMOVAL PROCEDURE
1. Open the rear compartment lid.
2. Remove the rear compartment lid trim.
3. Pull back on rear compartment trim panel.
4. Disconnect the backup lamp connector (5) from the rear compartment lid wiring harness.
5. Press the grommet (3) out of the rear compartment lid.
6. Remove the fasteners (4) securing the backup lamp (1) to the rear compartment lid (2).
7. Remove the backup lamp (1) from the rear compartment lid (2).
INSTALLATION PROCEDURE
1. Route the backup lamp connector (5) and the grommet (3) through the rear compartment lid (2).
2. Install the backup lamp (1) to the rear compartment lid (2).
3. Install the fasteners (1) in order to secure the backup lamp (1) to the rear compartment lid (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 4.5 N.m (40 lb in).
4. Verify that the grommet (3) is fully seated in the rear compartment lid (2).
5. Connect the backup lamp connector (5) to the rear compartment lid wiring harness.
6. Install the rear compartment lid trim.
7. Close the rear compartment lid.