Tail Lamp Replacement
TAIL LAMP REPLACEMENTREMOVAL PROCEDURE
1. Open the rear compartment lid.
2. Remove the left or right rear compartment side trim.
3. Disconnect the taillamp connector (3).
4. Press the grommet (2) out of the rear compartment.
5. Remove the fasteners (5) securing the tail lamp (1) to the body.
6. Remove the taillamp (1) from the body.
INSTALLATION PROCEDURE
1. Route the taillamp connector (3) and the grommet (2) through the body.
2. Verify that the grommet (2) is fully seated in the body.
3. Install the taillamp (1) to the body.
4. Install the fasteners (5) in order to secure the taillamp (1) to the body.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 4.5 N.m (40 lb in).
5. Connect the taillamp connector (3).
6. Install the rear compartment side trim.
7. Close the rear compartment lid.