Underhood Electrical Center or Junction Block Replacement
UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the negative battery cable from the battery.
2. Remove the positive battery cable fastener.
3. Remove the positive battery cable.
4. Unclip the four retaining clips and lift the electrical fuse block (1) out of the base.
5. Turn the fuse block over in the base in order to remove the electrical connectors.
6. Remove the three connector fasteners and remove all the electrical connectors from the fuse block.
7. Remove the three fasteners (1,3) from the fuse block base (2).
8. Remove the fuse block base (2) from the vehicle
INSTALLATION PROCEDURE
1. Install the fuse block base (2) to the body.
2. Install the fuse block base fasteners (1,3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
- Tighten the two base nuts (1) to 6 N.m (53 lb in).
- Tighten the remaining base bolt (3) to 9 N.m (80 lb in).
1. Place the fuse block in the fuse block base, with the bottom up.
Install all the connectors to the fuse block and hand start the fasteners.
Tighten
Tighten the fasteners to 6.6 N.m (58 lb in).
2. Install the front fuse block (1) into the base assembly.
Ensure all the clips are engaged in order to retain the fuse block (1).
3. Install the positive battery cable and fastener to the front fuse block.
Tighten
Tighten the fastener to 15 N.m (11 lb ft).
4. Connect the negative battery cable from the battery.