Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT







REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the MAP sensor electrical connector.
3. Remove the throttle cable bracket bolts and bracket.
4. Remove the MAP (1) sensor from the intake manifold.
5. Inspect the MAP sensor grommet for wear or damage. If a problem is found, replace as necessary.







INSTALLATION PROCEDURE
1. Install the MAP sensor (1) into the intake manifold.
2. Install the throttle cable bracket and bolts.

NOTE: Refer to Fastener Notice in Service Precautions. Vehicle Damage Warnings


Tighten
Tighten the bracket bolts to 12 N.m (106 lb in).

3. Connect the MAP sensor electrical connector.