Crankshaft, Engine

Crankshaft Balancer Bolt
First Pass 50 Nm (37 ft. lbs.)
Final Pass +120 degrees
Crankshaft Position Sensor Bolt 10 Nm (89 inch lbs.)

Bearings
Crankshaft, Main, Bearing Material Aluminum
Production Clearance 0.015-0.055 mm (0.0006-0.0022 inch)
Service - Maximum 0.0635 mm (0.0025 inch)
Connecting Rod Bearing Material Aluminum
Production Clearance 0.025-0.076 mm (0.0010-0.0030 inch)
Service - Maximum 0.076 mm (0.0030 inch)

Crankshaft
Journals Crankshaft, Main, Diameter 64.350-64.366 mm (2.5335-2.5341 inch)
Runout #1, #5 0.022 mm (0.0009 inch)
Runout #2, #3, #4 0.025 mm (0.0010 inch)
Round 0.005 mm (0.0002 inch)
Taper 0.005 mm (0.0002 in)
Width, #1, #2, #4, #5 24.540-24.660 mm (0.9661-0.9709 inch)
Thrust #3, Wall Width 25.150-25.250 mm (0.9902-0.9941 inch)
Runout 0.040 mm (0.0016 inch)
Square 0.010 mm (0.0004 inch)
Crankpin, Connecting Rod, Diameter 53.947-53.963 mm (2.1239-2.1245 inch)
Round 0.005 mm (0.0002 inch)
Taper 0.005 mm (0.0002 inch)
Width 43.840-43.960 mm (1.7260-1.7307 inch)
End Play, Production 0.050-0.500 mm (0.0020-0.0197 inch)
Service - Maximum 0.500 mm (0.0197 inch)
Flange, Engine Flywheel, Face Runout 0.025 mm (0.0010 inch)
Rear Seal, Diameter 95.880-95.980 mm (3.7748-3.7787 inch)
Runout 0.025 mm (0.0010 inch)
Nose Diameter, 0.0-21.0 mm (0.000-0.827 inch), From Front Face 34.500-34.750 mm (1.3583-1.3681 inch)
Runout 0.100 mm (0.0039 inch)
21.0-53.00 mm (0.827-2.087 inch), From Front Face 34.892-34.912 mm (1.3737-1.3745 inch)
Runout 0.030 mm (0.0012 inch)
53.00 mm (2.087 inch), From Front Face, to Rolled Fillet 33.450-33.550 mm (1.3169-1.3209 inch)
Runout 0.100 mm (0.0039 inch)
89.94-110.54 mm (3.541-4.352 inch), From Front Face 44.950-45.000 mm (1.7697-1.7717 inch)
Runout 0.025 mm (0.0010 inch)
Crankshaft Balancer
Hub Inside Diameter 34.847-34.864 mm (1.3719-1.3726 inch)
Outside Diameter, Without Wear Sleeve 50.730-50.870 mm (1.9972-2.0028 inch)
Runout 0.100 mm (0.0039 inch)