Power Recliner Motor Replacement - Front Seat

POWER RECLINER MOTOR REPLACEMENT - FRONT SEAT

REMOVAL PROCEDURE

CAUTION: Refer to SIR Caution in Service Precautions.

1. Remove the front bucket seat.
2. Remove the power recliner position sensor.
3. Disconnect the electrical connector from the motor.




4. Remove the recliner motor retaining nuts (1).
5. Slide the motor off of the shaft.

INSTALLATION PROCEDURE
1. Slide the recliner motor on to the shaft

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the recliner motor nuts (1).

Tighten
Tighten the nuts to 10 N.m (88 lb in).

3. Install the electrical connector.
4. Install the recliner position sensor.
5. Install the seat into the vehicle.