Drive Cable Replacement - Horizontal
DRIVE CABLE REPLACEMENT - HORIZONTALREMOVAL PROCEDURE
CAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in Restraint Systems.
2. Remove the seat assembly.
3. Remove the seat cushion to gain access to the horizontal seat adjuster motor.
4. Disconnect the electrical connectors from the motor.
5. Remove the screws from the top of the adjuster motor.
6. Remove the seat adjuster drive cable (1) by pulling the cable out of the motor.
7. Remove the seat adjuster motor.
8. Remove the short drive cable from the seat adjuster.
INSTALLATION PROCEDURE
1. Position the short drive cable into the seat adjuster.
2. Line up the square end of the cable with the motor.
3. Slide the motor on to the cable.
4. Install the long drive cable (1) into the motor.
5. Install the long cable into the seat adjuster.
6. Ensure that both cables are fully seated.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the motor retaining screws.
Tighten
Tighten the screws to 5 N.m (44 lb in).
8. Connect the electrical connectors.
9. Install the seat cushion.
10. Install the seat assembly.
11. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in Restraint Systems.
12. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure.