Headlamp: Description and Operation

HEADLAMPS

The headlamps consist of 2 interchangeable single filament bulbs or 2 high intensity discharge (HID) arc tubes and ballast on each side of the vehicle which provide high and low beams. The lower bulb in the headlamp is the high beam and the upper bulb is the low beam.

The headlamps may be turned ON in 3 different ways:
- When the headlamp switch is placed in the ON position, for normal operation
- When the headlamp switch is placed in the AUTO position, for automatic lamp control (ALC)
- When the headlamp switch is placed in the AUTO position, with the windshield wipers ON in daylight conditions, after a 6 second delay

With the headlamp switch in the ON position, the headlamp switch headlamp ON signal circuit is grounded through the headlamp switch to G200. In response to this input, the dash integration module (DIM) provides ground to either the headlamp low beam relay control circuit or the headlamp high beam relay control circuit. The position of the dimmer switch determines which relay coil has ground. The DIM supplies battery positive voltage to the relay coil circuits, if the headlamps are necessary. The fuse block underhood supplies battery positive voltage to both relay switch circuits. When the low beam relay coil is energized, current flows through the LT LOW BEAM fuse and the RT LOW BEAM fuse to the low beam headlamps. The low beam headlamps have ground at G104. When the headlamp high beam relay coil is energized, current flows through the LT LOW BEAM fuse and the RT LOW BEAM fuse to the high beam headlamps. The high beam headlamps also have ground at G104. When the headlamp dimmer switch lever is pulled toward the driver, the flash to pass (FTP) switch closes. This grounds the DIM flash to pass switch signal. In response to this input, the DIM energizes the high beam relay. Both high beams remain on until the driver releases the switch handle. If the low beam headlamps were on during FTP operation, the low beams remain on. The headlights may be switched to high beam with the opposite movement of the dimmer switch lever. All CTSs exported to Norway, Sweden, Finland, or Israel will operate so that the low beam headlamps will also remain illuminated when the dimmer switch is in the high beam position. With the dimmer switch in the high beam position the DIM sends a class 2 message to the instrument panel cluster (IPC) requesting the IPC to illuminate the high beam indicator. If the headlamp switch is left in the ON position, the inadvertent power control feature will turn off the headlights 10 minutes after the ignition switch is turned to the OFF position. If the driver places the headlight switch in the ON position after the ignition switch has been turned OFF, or if the ignition switch is in the ACCY position, the headlights will remain on until turned off or the battery runs dead.

During automatic lamp control (ALC) the headlamps will be in low beam operation during low light conditions. A HEADLAMPS SUGGESTED message will appear on the driver information center DIC when the headlamps and park lamps are off due to all exterior lighting controls being inactive when Dark conditions are sensed. The auto position of the headlamp switch is supplied ground at G200 and enables the auto lamp feature. When the ignition is ON the DIM will automatically turn the headlamps ON or OFF according to the Light/Dark photocell Status.

The headlamps ON with wipers feature operates when the following conditions are true:
- The ignition is in the RUN position.
- The headlamps are currently OFF.
- The headlamp switch is in the AUTO position.
- The ambient light sensor indicates DAYTIME conditions.

When the headlamps ON with wipers feature is active the DIC will display the HEADLAMPS SUGGESTED message.