Service Procedure

Inspection Procedure

The following information provides instructions for inspecting the front seat track to floor pan attachments on both the driver and front passenger seats.

1. Open the left front door and move the front driver's seat to the full rearward position.





2. Inspect the INBOARD and OUTBOARD front seat track attachments (1) to the floor pan. Make sure that the hooks are inserted into the slots (2) in the floor pan and are not on top of the carpet (3) or on top of the floor pan underneath the carpet.

^ If one or both of the front seat tracks attachment are NOT inserted into the slots in the floor pan, proceed to the Repair Procedure section below.

^ If both the INBOARD and OUTBOARD front seat tracks are inserted into the slots (4) in the floor pan on both driver and passenger seats, no repairs are required. Install the GM Recall Identification Label.

Repair Procedure





1. Move the seat that is not installed properly to the full forward position.





2. Open the rear side door and remove the inboard seat track cover (1).

3. Remove the bolts attaching the rear of the seat track to the floor pan.

4. Move the complete seat assembly as necessary to insert the hooks on both the inboard and outboard seat tracks into the slots in the floor pan.

5. With the hooks fully inserted in the floor pan slots, install the two bolts that attach the rear of the seat track to the floor.

Tighten

Tighten the bolts to 30 Nm (22 lb-ft).

6. Reinstall the inboard rear seat track cover.

7. If necessary, repeat this procedure on the other front seat.

8. Install the GM Recall Identification Label.

Recall Identification Label

Place a Recall Identification Label on each vehicle corrected in accordance with the instructions outlined in this Product Recall Bulletin. Each label provides a space to include the recall number and the five (5) digit dealer code of the dealer performing the recall service. This information may be inserted with a typewriter or a ball point pen.

Put the Recall identification Label on a clean and dry surface of the radiator core support in an area that will be visible to people servicing the vehicle.

For US and IPC

When installing the Recall Identification Label be sure to pull the tab to allow the adhesion of the clear protective covering. Additional Recall Identification Labels for US dealers can be obtained from Dealer Support Materials by ordering on the web from DWD Store.

Additional Recall Identification Labels for IPC dealers can be obtained from your Regional Marketing Office.

For Canada

Additional Recall Identification Labels for Canadian dealers can be obtained from DGN.